Buscar

Estamos realizando la búsqueda. Por favor, espere...

 Detalle_Publicacion

Design of indoor WLANs: Combination of a ray-tracing tool with the BPSO method

Abstract: This article presents an approach that combines a ray-tracing tool with the binary version of the particle swarm optimization (BPSO) method to the design of infrastructure-mode indoor wireless local area networks (WLANs). This approach uses the power levels of a set of candidate access point (AP) locations obtained with the ray-tracing tool at a mesh of potential receiver locations or test points to allow the BPSO optimizer to carry out the design of the WLAN. For this purpose, several restrictions are imposed through a fitness function that drives the search toward the selection of a reduced number of AP locations and their channel assignments while keeping low transmission power levels. During the design, different coverage priority areas can be defined, and the signal-to-interference ratio (SIR) levels are kept as high as possible to comply with the quality-of-service (QoS) requirements imposed. The performance of this approach in a real scenario at the authors' premises is reported, showing its usefulness.

 Autoría: Moreno J., Domingo M., Valle L., Lopez J., Torres R., Basterrechea J.,

 Fuente: IEEE Antennas and Propagation Magazine, 2015, 57 (6), 22 - 33

Editorial: Institute of Electrical and Electronics Engineers

 Fecha de publicación: 01/12/2015

Nº de páginas: 30

Tipo de publicación: Artículo de Revista

 DOI: 10.1109/MAP.2015.2480078

ISSN: 1045-9243,1558-4143

Proyecto español: TEC2008-02730 ; TEC2012-33321

Url de la publicación: https://doi.org/10.1109/MAP.2015.2480078